ICP Hot Surface Igniter Kit for RGS102HSBA0AAA — OEM 1171306 | Ships Today

Overview

This OEM hot surface igniter kit pairs igniter 1171306 with wiring harness kit 1188370 for the ICP / Tempstar / Heil RGS102HSBA0AAA gas furnace. On each heat call the control board sends line voltage to the igniter, which glows white-hot to ignite the burner gas. Hot surface igniters are brittle and degrade with every cycle; the element eventually develops hairline cracks or burns out entirely, leaving the furnace unable to light. The included wiring kit replaces the original connector and leads, which often become heat-damaged or brittle right alongside the igniter — installing both together prevents a repeat no-heat call from a failed plug or chafed wire.

Specifications

Compatibility

Built for the ICP Tempstar Heil RGS102HSBA0AAA furnace and related models that use this hot surface igniter and connector. Match the igniter's mounting tab and connector style to the original before installing.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker; verify zero voltage with a multimeter.
2. Access — Remove the burner compartment door to reach the igniter near the burners.
3. Document — Photograph the igniter position and harness routing before disconnecting.
4. Remove — Unplug the igniter lead, remove the mounting screw, and lift out the old igniter without touching the new element with bare fingers.
5. Install — Mount the new igniter, install the wiring kit connector, and route leads clear of hot surfaces.
6. Test — Restore power, start a heat cycle, and confirm the igniter glows and the burners light promptly.

Signs You Need a Replacement

• Furnace blower runs but burners never ignite (no heat)
• Igniter shows cracks or no longer glows on a heat call
• Repeated ignition lockout after several failed attempts
• Melted or brittle igniter plug and wiring

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.