ICP Hot Surface Igniter Kit for RGS101SRAB0AAAA — Igniter + Wiring | Ships Today

Overview

This genuine OEM hot surface igniter (part 1171306) with matching igniter wiring kit (part 1188370) provides reliable ignition for the ICP Tempstar Heil RGS101SRAB0AAAA gas furnace. On each heat call, the control board energizes the igniter, which glows red-hot to light the burners. Hot surface igniters are brittle and wear out over time, and the supply wiring/connector can become brittle or corroded from repeated heat cycling. A cracked igniter or a degraded harness is the leading cause of no-heat conditions, ignition lockout, and short cycling. This kit restores dependable, on-the-first-try ignition.

Specifications

Compatibility

Built for the ICP Tempstar Heil RGS101SRAB0AAAA gas furnace and related ICP-family furnaces using the same hot surface igniter and connector. Confirm igniter style and mounting before ordering.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker, then verify zero voltage with a multimeter.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter position and wiring routing before disconnecting.
4. Remove — Unplug the igniter harness, remove the mounting screw, and carefully extract the old igniter (handle only by the ceramic base — never touch the element).
5. Install — Mount the new igniter, route and connect the new wiring kit, and confirm the element sits correctly over the burner.
6. Test — Restore power, start a heat call, and verify the igniter glows and the burners light promptly.

Signs You Need a Replacement

• Furnace blows cold air or won't ignite.
• Igniter does not glow on a heat call.
• Visible cracks or breaks in the igniter element.
• Repeated ignition lockout or short cycling.

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.