ICP Hot Surface Igniter Kit for RGS101SFBA0AAAA — Includes Igniter Wiring Harness | Ships Today

Overview

This OEM hot surface igniter kit replaces the ignition source on your ICP Tempstar Heil RGS101SFBA0AAAA gas furnace. The kit includes igniter part number 1171306 and the matching igniter wiring kit 1188370, so you get the complete ignition assembly in one package. The hot surface igniter glows to a high temperature on each call for heat, lighting the burners as gas is released. It is one of the most common furnace failure points because the silicon-carbide or silicon-nitride element is brittle and degrades with every ignition cycle. When it cracks or burns out, the furnace will not light and you lose heat.

Specifications

Compatibility

Engineered for the ICP Tempstar Heil RGS101SFBA0AAAA furnace and shared platforms across the ICP family of brands. Always match the OEM part number to confirm fitment for your unit.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker, then verify zero voltage with a multimeter. Shut off the gas.
2. Access — Remove the furnace burner compartment service panel.
3. Document — Photograph the igniter mounting and all wiring before disconnecting.
4. Remove — Unplug the igniter harness, remove the mounting screw, and lift out the old igniter without touching the element with bare hands.
5. Install — Mount the new igniter, route and connect the new wiring kit per your photo, and seat it so the element aligns with the burner.
6. Test — Restore gas and power, then watch a full ignition cycle to confirm the igniter glows and lights the burners.

Signs You Need a Replacement

• Furnace blower runs but burners never ignite
• Visible cracks, blistering, or no glow on the igniter element
• Furnace short-cycles or locks out after several failed ignition attempts
• Control board flashes an ignition-failure fault code

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.