ICP Hot Surface Igniter Kit for RGS101HSAB0AAAA — OEM 1171306 | Ships Today

Overview

This OEM hot surface igniter (part 1171306), paired with its matching igniter wiring kit (part 1188370), fits the ICP / Tempstar / Heil RGS101HSAB0AAAA gas furnace. On a call for heat, the control board energizes the igniter, which glows red-hot to light the burners. Hot surface igniters are brittle and degrade with every cycle, so they are a leading cause of no-heat service calls. The included wiring kit ensures a clean, weather-tight connection and the correct pin orientation, preventing the intermittent faults that come from a cracked element or a corroded connector.

Specifications

Compatibility

Direct OEM fit for the ICP Tempstar Heil RGS101HSAB0AAAA and shared-platform furnaces. Verify your model number and igniter part number before ordering, and use the included wiring kit for a correct connector match.

Installation Guide

1. Safety First — Disconnect electrical power and shut off the gas supply, then verify zero voltage with a multimeter.
2. Access — Remove the burner-compartment service panel.
3. Document — Photograph the igniter mounting bracket and connector routing before disconnecting.
4. Remove — Unplug the igniter connector, remove the mounting screw, and carefully withdraw the old igniter without touching the element.
5. Install — Handle the new igniter only by its ceramic base, mount it in the original position, and connect it using the new wiring kit.
6. Test — Restore gas and power, start a heat cycle, and confirm the igniter glows and lights the burners promptly.

Signs You Need a Replacement

• No heat — burners never ignite on a call
• Visible cracks or breaks in the igniter element
• Igniter glows weakly or not at all
• Furnace locks out after several failed ignition attempts

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.