ICP Hot Surface Igniter Kit for RGS091SFCB0AAA — With Wiring Harness | Ships Today

Overview

This OEM hot surface igniter kit for the ICP/Tempstar/Heil RGS091SFCB0AAA gas furnace includes the igniter element (part 1171306) and its matching wiring kit (part 1188370) for a complete, reliable ignition repair. On each heat call the control board sends voltage to the igniter, which glows red-hot to light the burners. Hot surface igniters are brittle and degrade with every cycle — a cracked or worn element is the single most common cause of a furnace that clicks but won't light, short-cycles on ignition lockout, or blows cold air. The included wiring kit ensures a clean electrical connection and eliminates the corroded or brittle leads that often accompany an aged igniter.

Specifications

Compatibility

Direct OEM-fit replacement for the ICP/Tempstar/Heil RGS091SFCB0AAA gas furnace. The igniter mounts in the factory bracket and the wiring kit plugs into the original harness connector for a no-modification install.

Installation Guide

1. Safety First — Shut off gas and electrical power. Verify zero voltage with a multimeter before proceeding.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter mounting position and harness routing.
4. Remove — Unplug the igniter lead, remove the mounting screw, and carefully withdraw the old element — handle only by the ceramic base, never the glowing tip.
5. Install — Seat the new igniter in the bracket without touching the element, then connect the new wiring kit to the harness per your photo.
6. Test — Restore gas and power, run a heat call, and confirm the igniter glows and the burners light promptly.

Signs You Need a Replacement

• Furnace clicks but burners never light
• Igniter shows cracks or doesn't glow
• Repeated ignition lockout / short-cycling
• Cold air blowing with no flame

Shipping & Returns

Ships same day on orders placed before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.