ICP Hot Surface Igniter Kit for RGS091LRCA0AAA — OEM 1171306 | Ships Today

Overview

This OEM hot surface igniter kit for the ICP / Tempstar / Heil model RGS091LRCA0AAA includes the genuine igniter (part 1171306) and the matching igniter wiring kit (part 1188370). The hot surface igniter glows to ignite the burners at the start of every heat cycle. Because it is heated and cooled hundreds of times each season, the brittle ceramic-and-element igniter is one of the most common furnace failure points. When it cracks or burns out, the furnace cannot light and locks out on ignition failure. The included wiring kit ensures a clean, weather-tight connection to the control board.

Specifications

Compatibility

A direct OEM fit for the ICP-family model RGS091LRCA0AAA, sold under the ICP, Tempstar, and Heil badges. Confirm your existing igniter part number is 1171306 and that your connector matches the included wiring kit before ordering.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker, then verify zero voltage with a multimeter.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter position and wiring routing before removal.
4. Remove — Unplug the igniter harness and remove the mounting screw; handle the old igniter only by its ceramic base.
5. Install — Mount the new 1171306 igniter without touching the element, then connect the 1188370 wiring kit.
6. Test — Restore power and run a heat cycle, confirming the igniter glows and the burners light cleanly.

Signs You Need a Replacement

• Furnace clicks and tries to start but never lights
• Igniter does not glow or glows weakly
• Visible cracks or breaks in the ceramic element
• Repeated ignition-failure lockouts after a few seconds

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.