ICP Hot Surface Igniter for WPG3304060RKC1 — Furnace Ignitor | Ships Today

Overview

This OEM hot surface igniter (P/N 1177663) is the component that ignites the gas burners on each heat call in your ICP Tempstar Heil WPG3304060RKC1. When the control board energizes it, the igniter element glows red-hot and lights the gas. Igniters are brittle and wear out — a cracked or aged element is one of the most common causes of no-heat. A failed igniter typically shows up as a furnace that goes through its sequence but never lights, or that locks out after several failed attempts.

Specifications

Compatibility

Direct OEM replacement for the ICP Tempstar Heil WPG3304060RKC1 and related WPG-series packaged gas units using this hot surface igniter. Confirm the connector style and bracket against your existing igniter.

Installation Guide

1. Safety First — Disconnect power and verify zero voltage with a multimeter; shut off the gas supply.
2. Access — Remove the burner compartment door.
3. Document — Photograph the igniter bracket position and harness routing.
4. Remove — Unplug the igniter harness, remove the mounting screw, and lift out the old igniter. Handle only by the ceramic base — never touch the element.
5. Install — Mount the new igniter in the same position and reconnect the harness; do not touch the silicon-carbide element.
6. Test — Restore gas and power and confirm the igniter glows and lights the burners on a heat call.

Signs You Need a Replacement

• Furnace sequences but burners never light (no heat)
• Visible crack or break in the igniter element
• Igniter does not glow when energized
• Unit locks out after repeated failed ignition attempts

Shipping & Returns

Ships same day on orders placed before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.