ICP Hot Surface Igniter for WFAR080C060B1 — Includes Igniter Bracket | Ships Today

Overview

This OEM hot surface igniter (HSI) kit replaces the original ignition components in your ICP Tempstar/Heil WFAR080C060B1 gas furnace. The kit includes OEM igniter 1176919 and its mounting bracket 1184324. The hot surface igniter glows red-hot at the start of each heating cycle to light the gas at the burners. Because it endures extreme thermal stress on every call for heat, the brittle silicon-carbide element is one of the most frequently replaced furnace parts. When it fails, the furnace will not produce heat — you will typically hear the inducer motor and gas valve attempt to fire, but no flame results. A cracked, pitted, or electrically open igniter is the most common cause of a no-heat furnace.

Specifications

Compatibility

Engineered as a direct-fit replacement for the ICP Tempstar Heil WFAR080C060B1 gas furnace. These igniters are shared across many ICP-family (International Comfort Products) furnaces sold under the Tempstar, Heil, Comfortmaker, and Arcoaire brands. Always verify your existing part number against 1176919 before ordering.

Installation Guide

1. Safety First — Shut off gas and disconnect electrical power at the furnace switch and breaker. Verify zero voltage with a multimeter.
2. Access — Remove the furnace burner-compartment service panel.
3. Document — Photograph the igniter position and wiring connector before disconnecting.
4. Remove — Unplug the igniter connector, remove the mounting screw, and lift out the old igniter and bracket. Handle the new igniter by the bracket only — skin oils on the element cause premature failure.
5. Install — Mount the new igniter and bracket in the same position, aligned over the burner, and reconnect the wiring per your photo.
6. Test — Restore gas and power, then run a full heat cycle to confirm the igniter glows and the burners light cleanly.

Signs You Need a Replacement

• Furnace runs the inducer and clicks but never lights or produces heat
• Igniter element is cracked, blistered, or no longer glows
• Continuity test reads open (infinite resistance) across the igniter
• Short cycling or intermittent ignition during cold weather

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.