ICP Hot Surface Igniter for RGS213LSCA0AAAA — OEM Electrode | Ships Today

Overview

This OEM igniter electrode (part 1179966) is the direct-fit ignition component for the ICP / Tempstar / Heil RGS213LSCA0AAAA gas furnace. On a call for heat, the igniter heats up and lights the burner gas at the start of every cycle. Constant heat-up and cool-down cycling makes the igniter brittle over time, and it is one of the most common no-heat failure points in a gas furnace. Symptoms include a furnace that goes through its sequence but never ignites, a visibly cracked or burned igniter element, repeated lockouts after a few seconds of gas flow, or no glow at all when you watch the ignition cycle. Because the element is fragile, this is a part many technicians replace proactively at seasonal service.

Specifications

Compatibility

Direct OEM replacement for the ICP / Tempstar / Heil RGS213LSCA0AAAA furnace and models that use this igniter electrode. Match the mounting bracket and connector against your existing igniter before installing, and handle the new element only by its ceramic base — never touch the silicon element.

Installation Guide

1. Safety First — Shut off gas and disconnect power at the breaker. Verify zero voltage with a multimeter before reaching into the burner compartment.
2. Access — Remove the furnace service panel to expose the igniter at the burner assembly.
3. Document — Photograph the igniter position, bracket orientation, and wire routing before removal.
4. Remove — Unplug the igniter connector and remove the mounting screw, then carefully lift the old element out without bumping the burners.
5. Install — Set the new igniter in the same position, secure the screw, and reconnect the plug. Avoid touching the element with bare fingers.
6. Test — Restore gas and power, then watch a full ignition cycle to confirm the igniter glows and the burners light promptly.

Signs You Need a Replacement

• Furnace cycles but burners never light (no-heat call).
• Cracked, chipped, or burned igniter element.
• No visible glow during the ignition sequence.
• Repeated ignition lockouts after a few seconds.

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.