ICP Hot Surface Igniter for RGS102LFBA0AAA — OEM Igniter + Wiring Kit | Ships Today

Overview

This genuine OEM hot surface igniter (part 1171306) with its matching wiring kit (part 1188370) lights the burners in the ICP / Tempstar / Heil RGS102LFBA0AAA gas furnace. On a call for heat, the control board energizes the igniter, which glows red-hot to ignite gas at the burners. Hot surface igniters are brittle and degrade with every cycle; a cracked or open igniter is one of the most common causes of a no-heat furnace. The included wiring kit replaces the connector and leads so you restore a clean, reliable electrical connection.

Specifications

Compatibility

Designed for the ICP RGS102LFBA0AAA gas furnace and the equivalent Tempstar, Heil, and Comfortmaker models using the same ignition system. Verify against your unit's parts breakdown before ordering.

Installation Guide

1. Safety First — Shut off gas, disconnect power, and verify zero voltage with a multimeter.
2. Access — Remove the burner-compartment service panel.
3. Document — Photograph the igniter position and wiring before disconnecting.
4. Remove — Unplug the igniter connector, remove the mounting screw, and lift out the old igniter — handle only by the ceramic base, never the element.
5. Install — Mount the new igniter without touching the silicon-carbide element, then connect the new wiring kit.
6. Test — Restore gas and power, call for heat, and confirm the igniter glows and the burners light.

Signs You Need a Replacement

• Furnace blows cold air / no ignition
• Igniter does not glow on a heat call
• Visible cracks or hot spots on the element
• Open circuit / out-of-spec resistance reading

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.