ICP Hot Surface Igniter for RGS101HRCB0AAA — OEM 1171306 | Ships Today

Overview

This OEM hot surface igniter (HSI) is the original ignition component for the ICP / Heil / Tempstar RGS101HRCB0AAA gas furnace. The igniter is energized at the start of each heating call, glowing red-hot to ignite the gas flowing from the burner manifold. It is one of the most common wear parts in a furnace because it cycles every time the unit fires and operates at extreme temperature. This listing covers OEM igniter 1171306 along with the matching igniter wiring kit (1188370), so you receive the correct connector and harness for a clean, factory-style replacement.

Specifications

Compatibility

Designed as the direct factory replacement for the RGS101HRCB0AAA furnace and the family of ICP-built RGS gas furnaces sold under the Heil, Tempstar, and Comfortmaker brands. Always confirm your model and serial tag before ordering.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and verify zero voltage with a multimeter. Shut off the gas supply.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter bracket position and wiring before disconnecting.
4. Remove — Unplug the igniter harness, remove the mounting screw, and lift out the old igniter without touching the silicon-carbide element.
5. Install — Mount the new igniter, install the wiring kit connector, and reconnect per your photo. Handle by the ceramic base only.
6. Test — Restore gas and power, then watch a full ignition cycle to confirm a clean light-off.

Signs You Need a Replacement

• Furnace clicks and the inducer runs, but there is no glow and no flame
• Visible cracks or breaks in the silicon-carbide element
• Short cycling or repeated ignition lockouts
• Igniter glows weakly or unevenly compared to new

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.