ICP Hot Surface Igniter for RGS091LFBA0AAAA — Silicon Carbide w/ Wiring Kit | Ships Today

Overview

The hot surface igniter lights the burners on your ICP Tempstar/Heil RGS091LFBA0AAAA gas furnace. On a call for heat, the control board energizes this igniter, heating its silicon carbide element until it glows and ignites the gas at the manifold. Igniters are among the most common no-heat failures: the brittle element cracks, develops hairline fractures, or simply burns through after thousands of cycles. This OEM kit pairs igniter part 1171306 with the matching igniter wiring kit 1188370, giving you the correct connector and pigtail for a clean, reliable replacement.

Specifications

Compatibility

Direct OEM replacement for the ICP Tempstar Heil RGS091LFBA0AAAA gas furnace and equivalent 90,000 BTU ICP-family models (Tempstar, Heil, Comfortmaker, Arcoaire) built on the same platform. Confirm against your unit's parts breakdown before ordering.

Installation Guide

1. Safety First — Shut off gas and disconnect electrical power. Verify zero voltage with a multimeter.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the igniter mounting and wire routing before disconnecting.
4. Remove — Unplug the igniter connector, remove the mounting screw, and withdraw the old igniter without touching the element.
5. Install — Mount the new igniter using the supplied wiring kit; handle by the ceramic base only, never the element. Reconnect per your photo.
6. Test — Restore gas and power, run a heat cycle, and confirm the igniter glows and lights the burners cleanly.

Signs You Need a Replacement

• Blower runs but burners never light (no ignition)
• Visible cracks, breaks, or white spots on the element
• Igniter glows weakly or not at all during a heat call
• Furnace locks out after repeated failed ignition attempts

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.