ICP Hot Surface Igniter Electrode for RGS214LSAA0AAAA — Furnace | Ships Today

Overview

This OEM hot surface igniter electrode (part #1179966) is what lights the burners in your ICP RGS214LSAA0AAAA gas furnace. On each heat call the control board sends voltage to the igniter, which glows red-hot to ignite the gas flowing from the burners. The igniter element is brittle and degrades with every heating cycle — it is the single most common furnace failure. A cracked or worn igniter is the usual reason a furnace blower runs but produces no heat. Handle the new igniter only by its ceramic base; oils from bare fingers on the element shorten its life.

Specifications

Compatibility

Direct OEM fit for the ICP RGS214LSAA0AAAA and compatible Tempstar, Heil, and Comfortmaker gas furnaces using igniter electrode 1179966. Match the mounting bracket and connector to your original before installing.

Installation Guide

1. Safety First — Shut off gas and disconnect electrical power; verify zero voltage with a multimeter.
2. Access — Remove the furnace burner-compartment door.
3. Document — Photograph the igniter position and wire routing before disconnecting.
4. Remove — Unplug the igniter connector and remove the mounting screw(s); withdraw the old igniter carefully.
5. Install — Mount the new igniter by its ceramic base only (never touch the element), then reconnect the plug.
6. Test — Restore gas and power and watch for a clean glow and burner ignition on a heat call.

Signs You Need a Replacement

• Furnace blower runs but no heat is produced
• Visible cracks or breaks in the igniter element
• Igniter glows weakly or not at all
• System locks out after several failed ignition attempts

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.