ICP Hot Surface Igniter Electrode for RGS213LRAA0AAAA — OEM 1179966 | Ships Today

Overview

This OEM igniter electrode (part #1179966) is the hot surface ignitor that lights the burners on the ICP Tempstar Heil RGS213LRAA0AAAA gas furnace. On each heat call the control board energizes the igniter, which glows red-hot to ignite gas at the burner. Hot surface igniters are brittle and wear out from thermal cycling — a cracked or open igniter is one of the single most common no-heat failures. Replacing it on a worn furnace is a routine, low-cost restoration of reliable ignition.

Specifications

Compatibility

Direct OEM fit for the ICP Tempstar Heil RGS213LRAA0AAAA gas furnace and closely related RGS-series ICP-family furnaces using the same ignition assembly. Confirm igniter style and mounting bracket against your original before installing.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker; verify zero voltage with a multimeter.
2. Access — Remove the burner-compartment service panel.
3. Document — Photograph the igniter position, bracket, and connector before disconnecting.
4. Remove — Unplug the igniter lead, remove the mounting screw(s), and lift out the old igniter — handle only by the ceramic base, never the element.
5. Install — Mount the new igniter at the same depth and alignment, then reconnect the lead. Do not touch the silicon-carbide element with bare fingers.
6. Test — Restore power and run a heat cycle; confirm the igniter glows and the burners light promptly.

Signs You Need a Replacement

• Furnace inducer runs but burners never ignite
• Igniter does not glow, or glows weakly
• Visible cracks, breaks, or white/blistered spots on the element
• Igniter reads open or out-of-range resistance on a meter

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.