ICP Gas Valve Support Bracket for RGS101HRBB0AAAA – OEM Mounting Hardware | Ships Today

Overview

This OEM gas valve support bracket (part 1178238) for the ICP / Tempstar / Heil RGS101HRBB0AAAA gas furnace secures and stabilizes the gas valve against the burner manifold assembly. The bracket holds the valve in proper alignment with the manifold and gas piping, preventing strain on the threaded connections and reducing vibration that can loosen joints over time. While not the valve itself, a correct support bracket is essential for a safe, leak-free gas valve installation and is often required when replacing or re-mounting the valve.

Specifications

Compatibility

Designed for the gas valve and manifold assembly of the ICP / Tempstar / Heil RGS101HRBB0AAAA gas furnace. The bracket matches the factory mounting holes and valve orientation for a precise OEM fit.

Installation Guide

1. Safety First – Shut off the gas supply and disconnect electrical power; verify zero voltage with a multimeter.
2. Access – Remove the burner compartment access panel.
3. Document – Photograph the gas valve and bracket orientation before removing anything.
4. Remove – Support the gas valve, then remove the screws securing the old bracket.
5. Install – Position the new bracket, secure the gas valve in correct alignment with the manifold, and tighten the mounting screws.
6. Test – Restore gas and power, then leak-check all gas joints with soap solution and run a heat cycle.

Signs You Need a Replacement

• Bent, cracked, or corroded valve bracket.
• Gas valve sagging or out of alignment with the manifold.
• Vibration or movement at the gas valve during operation.
• Bracket missing after a prior valve replacement.

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.