ICP Gas Valve Mounting Bracket for RGS180LTAA0AAAA — OEM 1184226 | Ships Today

Overview

This is the genuine OEM gas valve mounting bracket (part number 1184226) for the ICP Tempstar Heil RGS180LTAA0AAAA gas furnace. The bracket secures the gas valve in its correct position inside the burner compartment, holding it rigid against vibration and maintaining proper alignment of the manifold and burner orifices. A bent, corroded, or missing bracket lets the gas valve shift, which can strain the inlet/outlet gas piping, misalign the manifold, and create a potential gas-leak hazard. Replace the bracket whenever it is cracked, rusted through, or deformed during a valve swap.

Specifications

Compatibility

Designed as a direct-fit replacement for the ICP Tempstar Heil RGS180LTAA0AAAA furnace and other RGS-series models that share the same gas-train layout. Always verify the part number against your existing bracket before ordering.

Installation Guide

1. Safety First — Shut off the gas supply at the manual valve and disconnect electrical power; verify zero voltage with a multimeter.
2. Access — Remove the furnace service/burner panel.
3. Document — Photograph the gas valve, bracket orientation, and all piping before disconnecting.
4. Remove — Disconnect the gas valve from the manifold and inlet piping, unbolt the old bracket from the furnace chassis, and lift it out.
5. Install — Mount the new bracket, reattach the gas valve, and reconnect the gas piping using fresh pipe dope on all joints.
6. Test — Restore gas and power, leak-check every joint with soap solution, and verify a clean ignition cycle.

Signs You Need a Replacement

• Visible cracks, rust-through, or deformation of the bracket
• Gas valve that wobbles or shifts in the cabinet
• Misaligned manifold or burner orifices
• Stress or kinking on the gas inlet/outlet piping

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.