ICP Gas Valve Mounting Bracket for RGS180LDEA0AAAA — OEM 1184226 | Ships Today

Overview

This is the genuine OEM gas valve mounting bracket, ICP part number 1184226, for the ICP / Tempstar / Heil RGS180LDEA0AAAA gas furnace. This bracket secures the gas valve in the correct position within the burner compartment, keeping the valve, manifold, and burner orifices in proper alignment. A bent, cracked, or corroded bracket can allow the gas valve and manifold to shift, leading to poor burner alignment, flame impingement, or vibration noise. It is also commonly replaced during a gas valve swap or burner assembly service.

Specifications

Compatibility

Designed for the ICP / Tempstar / Heil RGS180LDEA0AAAA gas furnace and related RGS-series models that use the 1184226 gas valve bracket. Confirm the bracket part number and bolt pattern against your existing part before ordering.

Installation Guide

1. Safety First — Disconnect power at the switch and breaker and shut off the gas supply. Verify zero voltage with a multimeter.
2. Access — Remove the burner compartment service panel.
3. Document — Photograph the gas valve, bracket, and manifold positioning before disassembly.
4. Remove — Support the gas valve/manifold, then remove the fasteners holding the old bracket and lift it out.
5. Install — Position the new 1184226 bracket and refasten the gas valve/manifold to the correct alignment per your photo.
6. Test — Restore gas and power, leak-check all connections with soap solution, and run a full heat cycle.

Signs You Need a Replacement

• Gas valve or manifold is loose or shifts in the burner compartment
• Visible cracks, bends, or corrosion on the existing bracket
• Vibration or rattling noise from the burner assembly
• Bracket damaged or discarded during a gas valve replacement

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.