ICP Furnace Control Board Kit for RGX060KFCA0AAA — OEM Ignition Board | Ships Today

Overview

This genuine OEM control board kit (part 1183618) is the integrated furnace control that runs the entire heating sequence on the ICP/Tempstar/Heil RGX060KFCA0AAA gas furnace. It manages igniter timing, gas valve operation, inducer and blower relays, and the safety circuit that monitors limits, pressure switches, and flame sense. Sold as a kit, it includes the mounting hardware needed for a clean swap. When the board fails, the furnace may not respond to thermostat calls, short-cycle, run the blower continuously, or flash a fault code on the diagnostic LED. Replacing the board restores correct, safe heating sequencing.

Specifications

Compatibility

Built for the ICP family RGX060KFCA0AAA 60,000 BTU gas furnace and related RGX-series furnaces specifying the 1183618 control board kit, including matching Tempstar, Heil, and Comfortmaker models on the same control platform.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker, then verify zero voltage with a multimeter.
2. Access — Remove the blower/control access panel.
3. Document — Photograph every connector and wire location on the old board before removing anything.
4. Remove — Unplug all harnesses, remove the mounting screws, and lift out the failed board.
5. Install — Mount the new board with the included hardware and reconnect each harness exactly per your photos.
6. Test — Restore power and run a full heat cycle, confirming ignition, blower, and a normal diagnostic LED.

Signs You Need a Replacement

• Furnace does not respond to a thermostat heat call.
• Blower or inducer runs constantly or not at all.
• Repeated short-cycling or lockouts.
• Diagnostic LED is dark or flashing a hard-fault code.

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.