ICP Furnace Control Board Kit for RGX060KECA0AAA — OEM 1183618 | Ships Today

Overview

This is the OEM control board kit (part number 1183618) for the ICP/Tempstar/Heil RGX060KECA0AAA gas furnace. The integrated furnace control board is the brain of the unit — it manages the ignition sequence, sequences the inducer and blower motors, monitors safety limits and flame sensing, and controls timing for every heat and cool cycle. When the board fails, the furnace may not respond to the thermostat, may short-cycle, may fail to ignite, or may run the blower continuously. Boards commonly fail from voltage surges, cracked solder joints, blown onboard fuses, or burned relays. This kit includes the replacement board and the hardware needed for a clean swap.

Specifications

Compatibility

Designed as a direct-fit replacement control board kit for the ICP/Tempstar/Heil RGX060KECA0AAA furnace and other models originally equipped with board 1183618. Verify the existing board part number and connector layout before ordering.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker. Verify zero voltage with a multimeter.
2. Access — Remove the furnace control compartment service panel.
3. Document — Photograph every wire harness and plug location on the old board before disconnecting.
4. Remove — Unplug all connectors, remove the mounting screws, and lift out the failed board.
5. Install — Mount the new board, transfer any jumpers or DIP settings, and reconnect each harness exactly per your photo.
6. Test — Restore power and run a full heat cycle, confirming proper inducer, ignition, and blower sequencing.

Signs You Need a Replacement

• Furnace does not respond to thermostat calls
• Blower or inducer runs continuously or not at all
• Repeated lockouts or erratic short-cycling
• Visible burn marks, blown fuse, or scorched relays on the board

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.