ICP Furnace Control Board Kit for RGS213STCA0AAAA | Ships Today

Overview

This genuine OEM control board kit (part number 1183618) is the integrated furnace control (IFC) — the brain of your ICP/Tempstar/Heil RGS213STCA0AAAA gas furnace. It sequences the entire heating cycle: it powers the inducer, energizes the hot surface igniter, opens the gas valve, monitors the flame sensor, and times the blower on and off. It also manages safety lockouts and stores diagnostic fault codes on its LED. When the board fails you may see a completely dead furnace, a blower that runs constantly, ignition that never starts, or repeated lockouts with no clear cause. The kit ships with the mounting hardware and connector references needed for a clean swap.

Specifications

Compatibility

Directly fits the ICP/Tempstar/Heil RGS213STCA0AAAA gas furnace and ICP-family models that specify control board kit 1183618. Match the connector layout and board footprint to your existing control before installing.

Installation Guide

1. Safety First — Disconnect electrical power and shut off gas; verify zero voltage with a multimeter.
2. Access — Remove the furnace blower-compartment service panel.
3. Document — Photograph every connector and wire color on the old board before disconnecting.
4. Remove — Unplug each harness, release the board from its standoffs/screws, and lift it out.
5. Install — Mount the new board, then reconnect each harness exactly per your photos and the kit instructions.
6. Test — Restore gas and power, call for heat, and verify ignition, flame proving, and proper blower timing.

Signs You Need a Replacement

• Furnace completely unresponsive to a heat call
• Blower runs continuously or won't start
• Random lockouts or error codes with no failed component
• Visible burn marks, corrosion, or a blown fuse on the board

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.