ICP Furnace Control Board Kit for RGS213HDAA0AAAA — OEM Integrated Control | Ships Today

Overview

This OEM control board kit, ICP part number 1183618, is the integrated furnace control (IFC) that manages the entire heating sequence on your ICP, Heil, or Tempstar RGS213HDAA0AAAA gas furnace. The board orchestrates the inducer, ignition, gas valve, and blower timing while monitoring safety inputs such as the limit switch, pressure switch, and flame sensor. It is the brain of the furnace — when it fails, you may see no response to a heat call, a furnace stuck in lockout, blower or inducer that won't run, or erratic LED diagnostic fault codes. Supplied as a kit for a complete, reliable replacement.

Specifications

Compatibility

Direct OEM replacement kit for the ICP/Heil/Tempstar/Comfortmaker RGS213HDAA0AAAA gas furnace and related ICP-family units that specify the 1183618 control board kit. Verify the part number against your existing board before ordering.

Installation Guide

1. Safety First — Disconnect power at the switch and breaker, then verify zero voltage with a multimeter.
2. Access — Remove the furnace control/blower compartment service panel.
3. Document — Photograph every wire harness and terminal on the old board before disconnecting; note any DIP switch or jumper settings.
4. Remove — Unplug the connectors, remove the mounting screws or standoffs, and lift out the failed board.
5. Install — Mount the new board, transfer any settings, and reconnect each harness exactly per your photos.
6. Test — Restore power, call for heat, and verify a full ignition sequence with correct blower timing and no fault codes.

Signs You Need a Replacement

• No response to a thermostat heat call
• Furnace stuck in lockout or flashing error codes
• Inducer or blower fails to energize on demand
• Visible burn marks, corrosion, or a failed onboard fuse/relay

Shipping & Returns

Ships same day on orders placed before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.