ICP Furnace Control Board Kit for RGS180HEEA0AAAA — OEM Ignition Control | Ships Today

Overview

This OEM control board kit (OEM 1183618, "Kit Control Board") is the integrated furnace control (IFC) that runs the entire heating sequence on your ICP / Tempstar / Heil RGS180HEEA0AAAA. It manages the ignition sequence, sequences the inducer and blower, monitors the flame sensor and limit/pressure switches, and provides the 24V outputs that drive the igniter and gas valve. The kit ships with the mounting hardware and instructions needed for a direct replacement. A failed control board causes no ignition, no blower, error-code lockouts, or completely dead operation despite good power.

Specifications

Compatibility

Built for the ICP / Tempstar / Heil RGS180HEEA0AAAA and matching RGS180-series furnaces. Always cross-reference the part number printed on your existing board, as control boards are frequently superseded by updated kits.

Installation Guide

1. Safety First — Disconnect power at the breaker and verify zero voltage with a multimeter.
2. Access — Remove the furnace control/blower compartment panel.
3. Document — Photograph every wire and connector on the board, or transfer wires one at a time.
4. Remove — Disconnect all harness plugs and terminals, then unscrew the old board from its standoffs.
5. Install — Mount the new board from the kit and reconnect each connector exactly per your photo.
6. Test — Restore power, run a heat cycle, and confirm correct ignition, blower, and diagnostic LED status.

Signs You Need a Replacement

• No ignition sequence and no inducer/blower start
• Repeated lockouts or flashing fault codes on the board LED
• Burned, scorched, or corroded traces or relays
• Intermittent operation that resets when power is cycled

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.