ICP Furnace Control Board Kit for RGS150SECA0AAAA — OEM Integrated Module | Ships Today

Overview

This OEM control board kit (part number 1183618) is the integrated furnace control (IFC) that runs the entire heating sequence on the ICP / Tempstar / Heil RGS150SECA0AAAA. It manages inducer startup, pressure-switch verification, hot surface igniter timing, gas valve operation, flame sensing, and blower on/off delays, while monitoring safety limits and reporting fault codes through its diagnostic LED. As a kit, it ships with the mounting and connector hardware needed for a clean swap. Control boards fail from power surges, heat stress, corroded relays, and burnt traces around the gas valve and igniter terminals — and a failed board can stop heating entirely, cause erratic blower behavior, or trip random lockouts.

Specifications

Compatibility

Direct OEM fit for the ICP / Tempstar / Heil RGS150SECA0AAAA furnace and related ICP-family units that originally used control board 1183618. Verify the board layout and connector pinout against your existing board before installing.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker; verify zero voltage with a multimeter.
2. Access — Remove the furnace blower/control compartment panel.
3. Document — Photograph every connector and wire location before removing anything.
4. Remove — Unplug all harness connectors, remove the mounting screws, and lift out the old board.
5. Install — Mount the new board from the kit and reconnect every harness exactly per your photos.
6. Test — Restore power, run a full heat cycle, and confirm proper ignition, blower timing, and a steady status LED.

Signs You Need a Replacement

• No response on a call for heat (no inducer, no igniter)
• Blower runs constantly or won't start
• Random lockouts or shifting fault codes
• Visible burnt traces, scorched relays, or melted connectors

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.