ICP Furnace Control Board Kit for RGS150HEBA0AAAA — OEM Ignition Control | Ships Today

Overview

Genuine OEM control board kit (OEM Part 1183618, "KIT CONTROL BOARD") for the ICP / Tempstar / Heil RGS150HEBA0AAAA gas furnace. The integrated furnace control board is the brain of the unit — it sequences ignition, monitors safety switches and flame, and times the inducer and blower motors. When the board fails you may see no response to a call for heat, blower running constantly, or error codes flashing on the diagnostic LED. The kit ships with the board and required mounting/connection hardware.

Specifications

Compatibility

Fits the ICP / Tempstar / Heil RGS150HEBA0AAAA and related RGS-series furnaces specifying control board kit 1183618. Confirm the part number against your existing board before ordering.

Installation Guide

1. Safety First — Disconnect power and gas; verify zero voltage with a multimeter.
2. Access — Remove the control/blower compartment panel.
3. Document — Photograph every connector and wire location on the old board.
4. Remove — Unplug each harness, remove the mounting screws, and lift out the failed board.
5. Install — Mount the new board and transfer each connector to the identical position per your photos.
6. Test — Restore power and gas, run a full heat cycle, and confirm proper ignition, flame proving, and blower timing.

Signs You Need a Replacement

• No response to a call for heat
• Blower runs constantly or won't start
• Diagnostic LED flashing a hard-fault code
• Visible scorching or burnt traces on the board

Shipping & Returns

Ships same day on orders placed before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.