ICP Furnace Control Board Kit for RGS150HDBA0AAAA — OEM Ignition Board | Ships Today

Overview

This OEM control board kit (part 1183618) is the integrated furnace control (IFC) that runs the entire heating sequence on your ICP/Tempstar/Heil RGS150HDBA0AAAA. The board manages inducer operation, hot surface igniter timing, gas valve actuation, flame sensing, blower delays, and onboard safety lockouts. When it fails, the furnace can refuse to start, get stuck in a single stage, flash diagnostic fault codes, or run the blower continuously. Because it sits at the center of the ignition sequence, a faulty control board often mimics igniter, flame-sensor, or gas-valve problems — so it's worth confirming with the LED fault code before replacing. This kit ships with the replacement board ready to drop into your existing harness.

Specifications

Compatibility

Built for the ICP/Tempstar/Heil RGS150HDBA0AAAA and related ICP-family furnaces using this control kit. Match the board's connector layout and part number against your existing control before installing.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker, then verify zero voltage with a multimeter.
2. Access — Remove the furnace control-compartment panel.
3. Document — Photograph every wire and connector on the old board before unplugging anything.
4. Remove — Unplug each harness, release the mounting standoffs, and lift out the old board.
5. Install — Seat the new board on the standoffs and reconnect every harness exactly per your photo.
6. Test — Restore power and run a full heat cycle, confirming proper sequencing and a normal LED status code.

Signs You Need a Replacement

• No response on a heat call — inducer and igniter never energize
• Persistent or abnormal LED diagnostic fault codes
• Blower runs continuously or won't run at all
• Intermittent operation or random lockouts

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.