ICP Furnace Control Board Kit for RGS102SEBB0AAA — OEM | Ships Today

Overview

This OEM control board kit (part 1183618) is the brain of the ICP/Tempstar/Heil RGS102SEBB0AAA gas furnace. It manages the entire heating sequence — inducer startup, pressure switch proving, hot surface igniter timing, gas valve actuation, blower on/off delays, and safety lockouts — while monitoring flame sense and limit inputs. A failed board causes no-heat, short cycling, blower running constantly, or LED fault codes that never clear. This complete kit ships with the OEM board and mounting hardware so you can restore full furnace control and safety functions in one repair.

Specifications

Compatibility

Built for the ICP/Tempstar/Heil RGS102SEBB0AAA gas furnace and platform models using the same integrated control board. Match the OEM part number and connector layout before installing.

Installation Guide

1. Safety First — Disconnect power, verify zero voltage with a multimeter, and shut off the gas supply.
2. Access — Remove the furnace control compartment service panel.
3. Document — Photograph every connector and wire location on the board before disconnecting.
4. Remove — Unplug each harness, then unfasten the old board from its standoffs.
5. Install — Mount the new board, reconnect every harness exactly per your photo, and seat all plugs fully.
6. Test — Restore gas and power, call for heat, and verify the full ignition sequence and blower operation with no fault codes.

Signs You Need a Replacement

• No heat with flashing LED fault/error codes
• Furnace short cycles or locks out repeatedly
• Blower runs continuously or won't start
• Inducer, igniter, or gas valve never energizes in sequence

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. National HVAC Parts fitment guarantee.