ICP Furnace Control Board for RGS210HTEA0AAAA — OEM Ignition Control Kit | Ships Today

Overview

This OEM control board kit (part #1183618) is the integrated furnace control (IFC) for the ICP Tempstar/Heil RGS210HTEA0AAAA gas furnace. It governs the complete heating sequence — ignition timing, inducer and blower operation, flame sensing, and safety lockouts — and reports diagnostic codes through its onboard LED. A failed board commonly causes no-heat conditions, continuous blower operation, short-cycling, or erratic behavior that mimics other component failures. Because the board coordinates every part of the furnace, it is one of the first suspects on an intermittent or hard-to-diagnose unit. This is the genuine OEM replacement kit, guaranteeing correct relays, pin-out, and firmware for your furnace.

Specifications

Compatibility

Designed for the ICP Tempstar Heil RGS210HTEA0AAAA gas furnace. This OEM kit is a direct, like-for-like replacement. Confirm your existing board part number before ordering.

Installation Guide

1. Safety First — Disconnect power at the furnace switch and breaker; verify zero voltage with a multimeter.
2. Access — Remove the furnace blower-compartment service panel.
3. Document — Photograph every wire harness and connector on the existing board before disconnecting.
4. Remove — Unplug all harnesses, release the mounting standoffs/screws, and lift out the old board.
5. Install — Mount the new board and reconnect each harness exactly per your photos.
6. Test — Restore power, run a heat cycle, and confirm proper ignition, blower, and inducer operation with no fault codes.

Signs You Need a Replacement

• No response or no ignition on a heat call
• Blower or inducer runs continuously or fails to start
• Repeated short-cycling or safety lockouts
• Diagnostic LED flashing a control-fault code

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.