ICP Defrost Control Board for YG048GA1 — Heat Pump Defrost | Ships Today

Overview

This genuine OEM defrost control board (Part No. 1069364) is the brain of the defrost cycle on the ICP / Tempstar / Heil YG048GA1 heat pump. In heating mode the outdoor coil accumulates frost; the defrost board monitors elapsed run time and coil temperature, then commands the reversing valve, shuts the outdoor fan, and energizes auxiliary heat to clear the ice before returning to normal heating. A failed defrost board is a leading cause of an iced-over outdoor coil, poor heating performance, a unit stuck in defrost, or a heat pump that never defrosts at all.

Specifications

Compatibility

Designed for the ICP/Tempstar/Heil YG048GA1 heat pump and the broader ICP family of heat pumps that use this defrost board platform. Confirm the original board's part number and connector layout before ordering, as defrost board revisions vary by series.

Installation Guide

1. Safety First — Disconnect power at the disconnect and breaker, then verify zero voltage with a multimeter before touching the board.
2. Access — Remove the condensing unit's electrical access panel.
3. Document — Photograph every wire harness and the defrost sensor connection before disconnecting.
4. Remove — Unplug the connectors, release the board standoffs, and lift out the old board.
5. Install — Mount the new board, transfer the defrost time-pin/jumper setting to match the original, and reconnect each harness per your photo.
6. Test — Restore power and verify a normal call, then initiate or wait for a defrost cycle to confirm correct operation.

Signs You Need a Replacement

• Outdoor coil ices over and never clears in heating mode
• Heat pump stuck in defrost or runs defrost constantly
• No defrost cycle even when frost is heavy
• Outdoor fan or reversing valve not responding correctly

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.