ICP Contactor for RGS214HDHLBRETA — 30A 2-Pole & 40A 3-Pole 24V Coil | Ships Today

Overview

This OEM contactor is the high-voltage switch that powers the compressor and condenser fan on the ICP (Tempstar / Heil) RGS214HDHLBRETA. When the thermostat calls for cooling, the 24V coil pulls the contacts closed and sends line voltage to the compressor. This listing covers the 2-pole 30A contactor (1171554) and the 3-pole 40A contactor (1172449), both with a 24V coil. Contactors are a common failure point: the contacts pit and burn over thousands of cycles, the coil can fail open, or insects/debris can hold the contacts down. Symptoms include a buzzing or chattering unit, a compressor that won't start, or one that won't shut off. Specs: 24V coil, 30A (2-pole) or 40A (3-pole) contact rating.

Specifications

Compatibility

Designed for the ICP Tempstar/Heil RGS214HDHLBRETA. Match the pole count and amp rating to your existing contactor — confirm whether your unit uses the 30A 2-pole or 40A 3-pole before ordering.

Installation Guide

1. Safety First — Disconnect power at the disconnect and breaker; verify zero voltage with a multimeter.
2. Access — Remove the condensing-unit service panel.
3. Document — Photograph all line, load, and 24V coil wires before disconnecting.
4. Remove — Transfer wires one at a time, or label them; unscrew the old contactor from the bracket.
5. Install — Mount the new contactor and reconnect each wire to the matching terminal per your photo.
6. Test — Restore power and confirm the contactor pulls in and the compressor starts on a cooling call.

Signs You Need a Replacement

• Loud buzzing, humming, or chattering at the contactor
• Pitted, burned, or welded contacts
• Compressor won't start or won't shut off
• Coil reads open on a multimeter

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.