ICP Blower Motor Module for WAPT244A2 — 1/3 HP 230V | Ships Today

Overview

This OEM blower motor module (ICP part #1190332, also supplied as blower motor #1185024) is the 1/3 HP, 230V air-moving motor for the ICP / Tempstar / Heil WAPT244A2 system. The blower motor turns the indoor blower wheel, circulating conditioned air through the duct system on both heating and cooling cycles. As the motor wears or fails you will see reduced airflow, longer run times, overheating limit trips, or a total loss of indoor air circulation. Worn bearings, a failed run capacitor, or burned windings are the usual culprits. Installing a genuine OEM 1/3 HP 230V motor restores rated airflow and protects the rest of the system from the heat and pressure problems caused by poor air movement.

Specifications

Compatibility

Engineered as a direct-fit replacement for the ICP / Tempstar / Heil WAPT244A2 air handler. Verify the part number on your existing motor and confirm horsepower, voltage, and rotation before installing.

Installation Guide

1. Safety First — Disconnect power at the breaker and verify zero voltage with a multimeter.
2. Access — Remove the blower compartment service panel.
3. Document — Photograph all wire connections and the blower wheel set-screw position before disconnecting.
4. Remove — Loosen the wheel set screw, disconnect leads, unbolt the motor from the blower housing and slide it out.
5. Install — Mount the new motor, reset the wheel position, and reconnect every lead exactly per your photos.
6. Test — Restore power and confirm smooth start-up, correct rotation, and full airflow.

Signs You Need a Replacement

• Weak or no airflow from the supply registers.
• Motor hums but will not start, or starts slowly.
• Overheating that trips the limit switch and short-cycles the system.
• Grinding, squealing, or rattling bearing noise.

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.