ICP 24VAC Relay for SUP15M2301CIA — OEM L01H009 | Ships Today

Overview

This is a genuine OEM 24VAC control relay (part number L01H009, marked AG90-23242-024W) for the ICP / Tempstar / Heil SUP15M2301CIA package unit. The relay uses a 24-volt control coil from the low-voltage transformer circuit to switch a higher-load line component on and off — typically the blower or an auxiliary contactor. When the coil burns open or the contacts pit and stick, the affected load either won't energize or won't shut off, producing no-heat, no-cool, or continuous-fan symptoms. This factory part drops straight into the original relay position with the correct coil voltage and contact rating.

Specifications

Compatibility

Built as the factory-correct 24VAC relay for the ICP / Tempstar / Heil SUP15M2301CIA and shared across related SUP15 series package units that use the same low-voltage control circuit. Verify the printed part number (L01H009 / AG90-23242-024W) and confirm a 24-volt coil before installing.

Installation Guide

1. Safety First — Disconnect power at the disconnect and breaker, then verify zero voltage with a multimeter.
2. Access — Remove the control/service panel to reach the relay and low-voltage terminal board.
3. Document — Photograph all coil and load wiring before disconnecting.
4. Remove — Unplug the spade terminals and release the relay from its mounting clip or screws.
5. Install — Snap the new relay into place and reconnect each wire to the matching terminal per your photo.
6. Test — Restore power and confirm the relay clicks in on a call and the controlled load energizes correctly.

Signs You Need a Replacement

• Blower or load fails to energize on a thermostat call.
• Fan or component runs continuously and won't shut off.
• Audible chattering or buzzing from the relay.
• Burnt smell or visible scorching on the relay housing or contacts.

Shipping & Returns

Ships same day on orders placed before 3 PM CST. 30-day returns on unused parts. Backed by the National HVAC Parts fitment guarantee.