ICP 2-Pole Contactor for RHS102H0AB0AAAA — 30A/40A 24V Coil | Ships Today

Overview

This OEM 2-pole definite-purpose contactor switches line voltage to the compressor and outdoor fan motor on your ICP Tempstar Heil RHS102H0AB0AAAA heat pump. When the thermostat calls and the 24V coil energizes, the contacts close to power the condensing unit. Contactors fail from contact arcing, pitting, and coil burnout — a frequent cause of no-cool and no-heat service calls. Look for a humming or chattering contactor, contacts welded shut so the compressor never cycles off, visibly pitted or burnt contacts, or a coil that won't pull in despite 24V.

Specifications

Compatibility

Fits the ICP-built RHS102H0AB0AAAA heat pump and equivalent Tempstar, Heil, and Comfortmaker RHS102 models. Match the amperage to your existing contactor and verify pole count and coil voltage before installing.

Installation Guide

1. Safety First — Shut off the disconnect and breaker, then verify zero voltage with a multimeter.
2. Access — Remove the outdoor unit's electrical service panel.
3. Document — Photograph all line, load, and coil wiring before disconnecting.
4. Remove — Disconnect the wires, unscrew the old contactor, and lift it out.
5. Install — Mount the new contactor and transfer wires one at a time per your photo.
6. Test — Restore power, call for operation, and confirm the contacts close and the compressor runs.

Signs You Need a Replacement

• Loud buzzing, humming, or chattering at the contactor.
• Pitted, burnt, or welded contacts.
• Compressor runs continuously and won't shut off.
• 24V at the coil but contacts won't close.

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.