ICP 2-Pole Contactor for RGS091HFAB0AAAA — 30A & 40A 24V Coil OEM | Ships Today

Overview

This OEM 2-pole definite purpose contactor is the factory switching relay for the ICP/Tempstar/Heil RGS091HFAB0AAAA. Two ratings are offered: 30 amp (part 1178074) and 40 amp (part 1178211), both with a 24V control coil. The contactor uses the 24V signal from the thermostat/control board to energize its coil, closing the line-voltage contacts that power the compressor and condenser fan motor. Contactors are a high-wear component — the contacts arc every cycle and eventually pit, burn, or weld. Common failure symptoms include the outdoor unit not starting, a humming or chattering contactor, contacts that stick closed (unit runs continuously), or visible burning/pitting on the contact points.

Specifications

Compatibility

Direct OEM fit for the ICP/Tempstar/Heil RGS091HFAB0AAAA. Match the original amp rating (30A or 40A) and 24V coil before ordering.

Installation Guide

1. Safety First — Disconnect power at the breaker and disconnect; verify zero voltage with a multimeter.
2. Access — Remove the unit's electrical access panel.
3. Document — Photograph all line, load, and 24V coil wiring before disconnecting.
4. Remove — Transfer wires one at a time or label them, then unbolt the old contactor.
5. Install — Mount the new contactor, reconnect line/load and 24V coil leads per your photo.
6. Test — Restore power and confirm the contactor pulls in on a call for cooling and the compressor/fan start.

Signs You Need a Replacement

• Outdoor unit won't start on a cooling call.
• Loud humming, buzzing, or chattering from the contactor.
• Burnt, pitted, or welded contact points.
• Compressor runs continuously (contacts stuck closed).

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.