ICP 2-Pole 30A Contactor for RHS060S0CB0AAA — 24V Coil | Ships Today

Overview

This OEM 2-pole, 30-amp definite purpose contactor (ICP part #1178074, CONTACTOR 2P 30A 24V) is the main switching relay for the ICP/Tempstar/Heil RHS060S0CB0AAA condensing unit. When the thermostat calls for cooling, the 24-volt coil energizes and pulls the contacts closed, sending line voltage to the compressor and condenser fan motor. Contactors are high-wear parts: their silver contacts pit, burn, and weld over thousands of cycles. A failing contactor causes a no-cool condition, chattering or buzzing, contacts that stick closed (compressor won't shut off), or contacts that won't pull in at all. Replacing a worn 30A contactor restores reliable, clean switching and protects the compressor from voltage drop and arcing damage.

Specifications

Compatibility

Built for the ICP RHS060S0CB0AAA and shared ICP/Tempstar/Heil/Comfortmaker condensing units calling for a 2-pole 30A 24V coil contactor. Verify your original coil voltage is 24V and contact rating is 30A before installing.

Installation Guide

1. Safety First — Disconnect power at the disconnect and breaker, verify zero voltage with a multimeter.
2. Access — Remove the condenser service panel.
3. Document — Photograph all line, load, and coil wires before disconnecting.
4. Remove — Transfer wires one at a time, then unbolt the old contactor from its bracket.
5. Install — Mount the new contactor and reconnect each wire exactly per your photo.
6. Test — Restore power and confirm the contactor pulls in cleanly on a cooling call.

Signs You Need a Replacement

• Burned, pitted, or welded contacts
• Loud buzzing or chattering when the system runs
• Compressor won't start (contacts won't close) or won't shut off (contacts stuck)
• Visible arcing, melted plastic, or insect/debris fouling on the contacts

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.