ICP 2-Pole 30A Contactor for RHS060S0BB0AAAA – 24V Coil | Ships Today

Overview

This is a genuine OEM 2-pole 30-amp definite purpose contactor with a 24V coil (OEM part number 1178074) for ICP / Tempstar / Heil RHS060S0BB0AAAA condensing units. The contactor is the electrical switch that energizes the compressor and condenser fan motor whenever the 24V control circuit calls for cooling or heat-pump operation. Its double-pole contacts close to pass line voltage to the high-current loads. Contactors wear out from millions of make-and-break cycles: contacts pit, burn, and eventually weld closed or fail to close, while ants and debris can jam the armature. Common failure symptoms include a unit that won't start, a humming contactor that won't pull in, or an outdoor unit that runs continuously because the contacts have welded shut.

Specifications

Compatibility

Direct OEM replacement for the ICP Tempstar Heil RHS060S0BB0AAAA and other RHS060 series units using the 1178074 2-pole 30A 24V contactor. Confirm pole count, amp rating, and 24V coil before ordering.

Installation Guide

1. Safety First – Disconnect power at the breaker and verify zero voltage with a multimeter.
2. Access – Remove the service panel to reach the control compartment.
3. Document – Photograph all line, load, and 24V coil wiring before disconnecting.
4. Remove – Label and disconnect the wires, then unscrew the old contactor from its bracket.
5. Install – Mount the new contactor and reconnect each wire exactly per your photo.
6. Test – Restore power and confirm the contactor pulls in on a cooling call and the compressor and fan start.

Signs You Need a Replacement

• Outdoor unit won't start on a cooling call
• Loud humming or buzzing with no contact pull-in
• Compressor and fan run nonstop (welded contacts)
• Visibly pitted, burnt, or melted contacts

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.