ICP 1-Pole 25A Contactor for YE024G — 24V Coil | Ships Today

Overview

This OEM 1-pole, 25-amp contactor (part #14306501) is the electrical switch that energizes the compressor and condenser fan in your ICP YE024G heat pump. A 24V signal from the thermostat pulls in the contactor coil, closing the contacts and delivering line voltage to the compressor. Contactors are a high-wear part — the contacts pit, burn, and weld over thousands of cycles, while the coil can open or short. Failure shows up as a unit that won't start, a compressor that hums but won't run, or a system that won't shut off because the contacts have welded closed.

Specifications

Compatibility

Direct-fit replacement for the ICP YE024G and other ICP-family condensing units (Heil, Tempstar, Comfortmaker) specifying the 14306501 single-pole 25A contactor. Verify pole count, amp rating, and 24V coil against your existing part before ordering.

Installation Guide

1. Safety First — Disconnect power at the disconnect and breaker; verify zero voltage with a multimeter.
2. Access — Remove the condenser unit's electrical-panel cover.
3. Document — Photograph all line, load, and coil wires before disconnecting.
4. Remove — Transfer wires one at a time, or label them, then unbolt the old contactor.
5. Install — Mount the new contactor and reconnect each wire to match the photo.
6. Test — Restore power and confirm the contactor pulls in on a cooling call.

Signs You Need a Replacement

• Compressor hums but won't start
• Unit won't run on a cooling/heating call
• System won't shut off (welded contacts)
• Pitted, burnt, or chattering contacts

Shipping & Returns

Ships same day before 3 PM CST. 30-day returns. Backed by the National HVAC Parts fitment guarantee.