OEM Carrier Flame Sensor Assembly LH33WZ005 for Model PY1PNA030080ACBA

This OEM Carrier flame sensor assembly (part# LH33WZ005) is the factory-authorized replacement for the Carrier PY1PNA030080ACBA gas furnace. The flame sensor — also called a flame rod — is a critical safety component that sends a small microamp signal to the control board confirming that a burner flame is present. When it fails or becomes coated with oxidation, the control board cannot verify ignition and will shut off the gas valve within 5 to 8 seconds as a safety lockout. The result: your furnace lights briefly, then goes out repeatedly until the system locks out entirely.

• Specs: OEM Carrier flame sensor assembly | 64½" wire lead | Factory Authorized Parts (FAP) label | Direct OEM replacement for part# LH33WZ005 | Fits Carrier PY1PNA030080ACBA and related models
• OEM vs Generic: This is a genuine Factory Authorized Part manufactured to exact Carrier tolerances. Generic sensors often use inferior rod alloys that oxidize faster, shortening the service interval and risking nuisance lockouts. OEM is the correct choice for long-term reliability.
• Install difficulty: 2/5 — Turn off power and gas before servicing. The sensor is mounted in the burner box with a single screw and a push-on wire connector. Tools needed: 1/4" or 5/16" nut driver, needle-nose pliers. Lightly clean the rod with fine steel wool if replacing as part of a tune-up. No special tools required.
• Warranty: 1-year OEM factory warranty. In stock and ships same business day from our warehouse.

Compatibility: Designed for the Carrier PY1PNA030080ACBA gas furnace. Verify your unit's data plate and existing part number before ordering — our team is available to confirm fitment. Questions about compatibility? Contact us before you order and we'll verify the fit.