OEM Carrier Flame Sensor (48GS400192) for Model PY1PEB036060ABAA

This is the genuine OEM Carrier flame sensor, part number 48GS400192, factory-specified for the Carrier PY1PEB036060ABAA gas furnace. The flame sensor — also called a flame rod — is a critical safety component that uses ionization/rectification to confirm that a burner flame is present after ignition. When it fails or becomes coated with oxidation, the control board loses the flame signal and initiates a safety lockout, typically shutting the burner off within 5 to 8 seconds of ignition. The result: a furnace that appears to start, fires briefly, then shuts down and goes into lockout — often repeatedly cycling before triggering a fault code.

• Specs: 90° angled flame rod with mounting bracket | OEM part number 48GS400192 | Approximate rod length 1.6" | Overall dimensions approx. 4.9" × 1.75" | Direct factory replacement
• OEM vs Generic: This is a genuine Carrier OEM sensor — not an aftermarket substitute. OEM sensors meet factory metallurgy and geometry specs exactly, ensuring reliable ionization current readings and eliminating nuisance lockouts caused by off-spec rod positioning or alloy differences.
• Install Difficulty: 2/5 — Turn off power and gas before servicing. Remove the access panel, locate the sensor on the burner assembly, disconnect the single wire lead, and swap in the new sensor. Tools needed: 1/4" hex driver, needle-nose pliers. Clean the mounting surface before reinstalling. No soldering required.
• Warranty: Backed by a 1-year OEM manufacturer warranty against defects. Ships same business day from our warehouse — order by 3 PM local time.

Compatibility: Designed for the Carrier PY1PEB036060ABAA packaged gas furnace. Always verify your unit's data plate and existing part number before ordering. If you need fitment confirmation, our HVAC parts team is available to verify compatibility before you buy — same-day shipping available on all in-stock OEM parts.