OEM Carrier Condenser Fan Motor 1/4 HP 208-230V for Model PH4ANG036000BBAA

This factory-spec condenser fan motor is the correct replacement for the Carrier PH4ANG036000BBAA heat pump condenser unit. The condenser fan motor drives the outdoor fan blade, pulling air across the condenser coil to dissipate heat during cooling and absorb heat during heating. When this motor fails, symptoms include a condenser unit that runs but rapidly overheats and trips on high-pressure lockout, a fan blade that hums but won't spin, or a completely dead outdoor fan — all of which will cause the system to shut down to prevent compressor damage.

• Specs: 1/4 HP | 208-230V | 1100 RPM | Single-Phase | Frame 48 | 0.5" shaft diameter | Rotation: CW (shaft up) | Stud mountable | Requires 10 MFD 370V run capacitor (sold separately)
• OEM vs Generic: OEM-spec motors are wound to factory tolerances, ensuring correct amp draw (1.4A), matched thermal overload protection, and balanced shaft dimensions for direct blade fit — generic motors often deviate in shaft length and rotation, causing vibration, noise, and premature failure.
• Install difficulty: 3/5 — Disconnect power and discharge the run capacitor before starting. Tools needed: 5/16" nut driver, flat-head screwdriver, multimeter, needle-nose pliers. Always photograph wiring and note rotation direction before disconnecting the old motor. Replace the run capacitor at the same time to avoid repeat failures.
• Warranty: 1-year replacement warranty. In stock and ships same business day from our warehouse.

Compatibility: Direct replacement for Carrier model PH4ANG036000BBAA heat pump condensers. OEM part number HC39GE226 (superseded by HB39GQ230). Verify HP, voltage, RPM, rotation, and shaft size against your unit's data plate before ordering. Our fitment team is available to confirm compatibility before you buy.