OEM Carrier Control Transformer 60VA 115/208/230V–24V for Model PH13NR04800GAAAA

This is the factory-authorized OEM replacement control transformer for the Carrier PH13NR04800GAAAA heat pump system. Part number HT01AW229, this 60VA transformer steps down the 115/208/230V line voltage to the 24V AC signal that powers your thermostat, contactor coil, and all low-voltage control circuitry. When this transformer fails, the entire control circuit goes dead — your thermostat goes blank, the system refuses to respond to any commands, and you may measure zero voltage on the 24V secondary terminals. Replacing it with the correct OEM unit restores full system operation immediately.

• Specs: 60VA power rating | 115/208/230V AC primary (multi-tap) | 24V AC secondary | 50/60 Hz | Foot-mount configuration | Factory part number HT01AW229 / HT01AW229A
• OEM vs Generic: OEM transformers are wound to exact factory VA ratings and insulation class. Undersized or off-brand units can overheat, trip the integral fuse, or produce unstable 24V output that causes nuisance lockouts and board damage.
• Install difficulty: 2/5 — Shut off all power at the disconnect before beginning. Tools needed: multimeter, flathead and Phillips screwdrivers, wire nuts or spade terminals. Always verify 24V output on the secondary after installation before reconnecting load wiring.
• Warranty: 1-year OEM factory warranty. In stock and ships same business day from our warehouse.

Compatibility: Engineered as the OEM direct replacement for Carrier model PH13NR04800GAAAA. The multi-tap 115/208/230V primary makes this transformer compatible across a range of supply voltages — always confirm your unit's data plate voltage before wiring. Cross-references: HT01AW229A, CIN-TRAN, 30-BV2006, 30-1814A. Questions about fitment? Our HVAC parts specialists verify compatibility before you order.