OEM Carrier Condenser Fan Motor 1/10 HP 208-230V for Model PH13NR02400GAKAA

This is the factory OEM replacement condenser fan motor for the Carrier PH13NR02400GAKAA heat pump condensing unit. Part number HC34GE239 (also cross-referenced as HC34GE239A), this motor drives the outdoor fan blade that pulls air across the condenser coil to reject heat from the refrigerant circuit. When this motor fails, the condenser loses airflow, refrigerant pressures spike, and the system trips on high-pressure lockout — leaving you with no cooling or heating. Common failure symptoms include the outdoor fan not spinning, the unit shutting off shortly after startup, or the motor running hot and humming without turning.

• Specs: 1/10 HP | 208–230V, 60 Hz | 1100 RPM | 0.75 Amps | Single Phase | Frame 48Y (5-5/8" diameter) | CW Rotation (shaft up) | 1.5" Shaft | Closed Enclosure | Single Speed
• OEM vs Generic: This is a genuine OEM Carrier motor built to exact factory tolerances for the PH13NR02400GAKAA. Generic motors often deviate in shaft length, rotation direction, or amp draw — risking premature compressor failure from inadequate condenser cooling. OEM is the only guaranteed fit.
• Install Difficulty: 3/5 — Shut off power at the disconnect and breaker panel before beginning. Tools needed: 5/16" and 3/8" nut drivers, wire stripper, needle-nose pliers, multimeter, and fan blade puller. Always photograph all wiring connections before disconnecting leads. Note rotation direction (CW when viewed from shaft end) before removing the old motor.
• Warranty: 1-year OEM factory warranty. In stock and ships same business day from our warehouse.

Compatibility: Designed for Carrier model PH13NR02400GAKAA. Also fits select Bryant and Payne units sharing the HC34GE239 specification — verify HP, voltage, RPM, and frame size against your unit's data plate before ordering. Not sure it fits? Contact our team for free fitment verification before you buy.