OEM Carrier Condenser Fan Motor 1/5 HP 208-230V 825 RPM for Model PH12NA04800GAGAA

This is the factory-specified OEM condenser fan motor for the Carrier PH12NA04800GAGAA R-410A heat pump system. The condenser fan motor drives the outdoor fan blade to expel heat from the refrigerant coil. When it fails, the system will overheat and trip the high-pressure limit, causing the unit to short-cycle or shut down entirely — symptoms often misdiagnosed as a refrigerant or compressor issue. A seized or slow-running motor can also cause the compressor to fail from heat stress, making prompt replacement critical.

• Specs: 1/5 HP | 208-230V, 60 Hz, 1-Phase | 825 RPM, Single Speed | 0.95A Full-Load Amperage | Frame 48 | CWLE Rotation | 0.5" Diameter × 1.9" Long Shaft | Stud Mountable | Closed Enclosure
• Required Capacitor: This motor requires a 7.5 MFD 370V run capacitor. It is strongly recommended to replace the run capacitor at the same time as the motor — a capacitor out of tolerance accelerates motor winding failure and voids the motor warranty.
• OEM vs Generic: This is a genuine Carrier factory-authorized part (HC37GE210 / HC38GE231), manufactured to exact OEM tolerances. Generic aftermarket motors may carry ±10% winding variances that shorten service life and can void your system's remaining warranty coverage.
• Install Difficulty: 3/5 — Disconnect power and discharge any capacitors before beginning. Tools required: 5/16" and 1/4" nut drivers, needle-nose pliers, wire stripper, multimeter. Photograph all wiring connections before disconnecting. Verify fan blade pitch and rotation direction (CWLE — counter-clockwise when viewed from lead-wire/shaft-up end) before powering on. Note: part numbers HC37GE210 and HC38GE231 are both covered OEM numbers for this platform.
• Warranty: 1-year OEM factory warranty. Ships same business day from our climate-controlled warehouse when ordered before cutoff.

Compatibility: Engineered as the direct OEM drop-in replacement for Carrier model PH12NA04800GAGAA heat pump condensers. Cross-references OEM part numbers HC37GE210, HC37GE210A, and HC38GE231. Always verify voltage, HP, RPM, rotation, and shaft dimensions against your unit's data plate before ordering. Our HVAC parts specialists are available to confirm fitment — contact us before you order.