OEM Carrier Condenser Fan Motor 1/5 HP 208-230V 825 RPM for Model PH12NA042000AGAA

This is the OEM factory-specified condenser fan motor for the Carrier PH12NA042000AGAA heat pump / air conditioner. The condenser fan motor drives the outdoor fan blade, pulling air across the condenser coil to reject heat and protect the compressor from thermal overload. When this motor fails, you'll notice the outdoor unit running with no fan blade movement, the system short-cycling on high-pressure lockout, warm air at the supply registers, or a complete no-cooling condition — often accompanied by a buzzing or humming sound as the motor windings struggle to start.

• Specs: 1/5 HP | 208-230V | 60 Hz | 825 RPM | Single Phase | 0.95A FLA | Frame 48 | Clockwise Rotation (CWLE) | 0.5" Diameter × 1.9" Shaft | Stud Mountable | Closed Enclosure | Requires 7.5 MFD 370V Run Capacitor (sold separately — strongly recommended to replace at the same time)
• OEM vs Generic: These genuine Carrier OEM motors (HC37GE210 / HC38GE231) are wound and balanced to exact factory tolerances. Aftermarket motors often deviate in rotation direction, shaft length, or RPM, leading to poor airflow, premature bearing wear, and voided equipment warranties. If your unit is under a Carrier service agreement, OEM is required.
• Install Difficulty: 3/5 — Disconnect and lock out power before beginning. Tools needed: 1/4" and 5/16" nut drivers, needle-nose pliers, wire stripper, multimeter, and a wiring diagram (located inside the unit's access panel). Photograph all wiring connections before disconnecting. Note fan blade pitch and orientation before removal — incorrect reassembly causes airflow reversal. Capacitor discharge is mandatory before touching any terminals.
• Warranty: 1-year OEM factory warranty against defects. Ships same business day from our climate-controlled warehouse. Free ground shipping on orders over $99.

Compatibility: Direct OEM replacement for Carrier model PH12NA042000AGAA heat pump condensing units. Part numbers HC37GE210 and HC38GE231 are the primary and superseding OEM references for this application. Always verify voltage, HP, RPM, and shaft specs against your unit's data plate before ordering. Our HVAC parts specialists verify fitment before your order ships — call or chat with us today and get back up and running fast.