OEM Carrier Discharge Gas Thermostat HN68GA295 for Model 07EA022411

This is the OEM factory-specified Discharge Gas Thermostat (DGT) for the Carrier 07EA022411 commercial chiller/compressor unit. The discharge gas thermostat monitors the temperature of hot refrigerant gas leaving the compressor discharge port. When discharge temperatures exceed a safe threshold — typically caused by low refrigerant charge, a failing compressor, or abnormal system conditions — this sensor triggers a protective lockout, preventing catastrophic compressor damage. A failed or out-of-calibration DGT may cause nuisance lockouts, failure to start, or — more critically — unprotected compressor operation that leads to burnout.

• OEM Part Number: HN68GA295 | Carrier Factory Authorized Parts™ | Direct factory replacement for Carrier 07EA022411
• OEM vs Generic: This is a genuine Carrier Factory Authorized Part, calibrated to the exact temperature set point and response curve required by the 07EA022411 compressor circuit. Aftermarket thermostats may use wider tolerances, risking either premature trips or inadequate protection.
• Install Difficulty: 3/5 — Requires refrigerant system isolation and proper recovery procedures before accessing discharge line connections. Tools needed: refrigerant recovery unit, manifold gauge set, torque wrench, and multimeter for continuity verification. Recommended for qualified HVAC/R technicians only.
• Warranty: 1-year OEM manufacturer warranty. In-stock and ships same business day from our warehouse when ordered before cutoff.

Compatibility: Fits Carrier model 07EA022411 commercial reciprocating compressor/chiller units. Verify part number against your unit's data plate and service documentation before ordering. Not sure if this is the right part? Our HVAC parts specialists are available to confirm fitment before you buy.