{"product_id":"oem-goodman-flame-sensor-rod-for-amss960805cnaa-furnace-0130f00010s","title":"OEM Goodman Flame Sensor Rod for AMSS960805CNAA Furnace — 0130F00010S","description":"\u003ch2\u003eGoodman 0130F00010S Flame Sensor\u003c\/h2\u003e\u003cp\u003eThe Goodman 0130F00010S is a genuine OEM flame sensor (flame rod) for the \u003cstrong\u003eAMSS960805CNAA\u003c\/strong\u003e gas furnace. This single-rod sensor uses flame rectification to confirm the burners have actually lit; if it detects no flame current within a few seconds of ignition, the control board closes the gas valve as a safety measure. A dirty, corroded, or failed flame sensor is the number-one cause of a furnace that lights and then shuts off after 3–7 seconds, repeatedly short-cycling into a no-heat lockout.\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003e\n\u003cstrong\u003eType:\u003c\/strong\u003e Single-rod flame rectification sensor\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eFunction:\u003c\/strong\u003e Confirms burner flame; triggers safety shutoff on flame loss\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eMounting:\u003c\/strong\u003e Single-screw bracket at the burner assembly\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eBrand:\u003c\/strong\u003e Goodman \/ Amana (Daikin)\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eFits:\u003c\/strong\u003e AMSS960805CNAA and many Goodman\/Amana furnaces\u003c\/li\u003e\n\u003cli\u003e\n\u003cstrong\u003eOEM Part #:\u003c\/strong\u003e 0130F00010S\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch3\u003eOEM vs. Generic\u003c\/h3\u003e\u003cp\u003eThe genuine 0130F00010S uses the correct rod length, ceramic insulator, and mounting geometry so the tip sits properly in the flame envelope — critical for a reliable microamp signal. Aftermarket rods that sit too high or low in the flame produce a weak, drifting signal that causes intermittent lockouts. For a critical safety component, OEM is strongly recommended.\u003c\/p\u003e\u003ch3\u003eInstallation Difficulty\u003c\/h3\u003e\u003cp\u003e\u003cstrong\u003eEasy (2\/5)\u003c\/strong\u003e — about 10–15 minutes. Shut off power and gas, remove the single mounting screw, disconnect the sensor lead, and install the new rod. Do not touch the rod with bare fingers — skin oils reduce flame conductivity. Wipe with a clean cloth before start-up.\u003c\/p\u003e","brand":"Goodman","offers":[{"title":"Default Title","offer_id":63057797054835,"sku":"GOODMAN-7562","price":26.95,"currency_code":"USD","in_stock":true}],"url":"https:\/\/nationalhvacparts.com\/products\/oem-goodman-flame-sensor-rod-for-amss960805cnaa-furnace-0130f00010s","provider":"National HVAC Parts","version":"1.0","type":"link"}