{"product_id":"oem-goodman-flame-sensor-for-ameh961005dxaa-furnace-0130f00010s","title":"OEM Goodman Flame Sensor for AMEH961005DXAA Furnace — 0130F00010S","description":"\u003cp\u003eThe Goodman \u003cstrong\u003e0130F00010S Flame Sensor\u003c\/strong\u003e is a genuine OEM replacement rod for the Amana\/Goodman \u003cstrong\u003eAMEH961005DXAA\u003c\/strong\u003e 96% AFUE multi-speed gas furnace. The flame sensor confirms the burner has lit during each heating cycle; when the rod oxidizes or cracks, the control board loses its flame signal and shuts the furnace down — producing intermittent no-heat calls, short-cycling, and repeated ignition lockouts. Replacing this low-cost part is the single most common fix for a furnace that lights briefly then shuts off.\u003c\/p\u003e\u003cul\u003e\n\u003cli\u003eGenuine OEM Goodman\/Amana part number 0130F00010S\u003c\/li\u003e\n\u003cli\u003eDirect fit for AMEH961005DXAA and compatible AMEH96 series furnaces\u003c\/li\u003e\n\u003cli\u003eKanthal\/nickel flame rectification rod with integrated ceramic insulator\u003c\/li\u003e\n\u003cli\u003eIncludes spade terminal connection and single mounting screw location\u003c\/li\u003e\n\u003cli\u003eResolves flame-sense lockout codes and short-cycle faults\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch3\u003eOEM vs. Generic\u003c\/h3\u003e\u003cp\u003eOur \u003cstrong\u003eOEM version\u003c\/strong\u003e is the exact factory rod, guaranteeing correct rod length, insulator standoff, and micro-amp signal strength your control board expects. The \u003cstrong\u003egeneric version\u003c\/strong\u003e is a quality-matched aftermarket sensor built to the same fitment and electrical spec at a lower price — an excellent value for out-of-warranty repairs. Both are new, not refurbished.\u003c\/p\u003e\u003ch3\u003eInstallation Difficulty: Easy\u003c\/h3\u003e\u003cp\u003eRated \u003cstrong\u003eEasy (DIY-friendly, ~15 minutes)\u003c\/strong\u003e. Shut off power at the furnace switch, remove the single mounting screw, unplug the spade connector, and install the new sensor. Tip: never sand a new sensor — install it clean and dry. Always confirm gas and power are off before servicing. If replacement does not restore a steady flame signal, inspect the control board and burner ground.\u003c\/p\u003e","brand":"Goodman","offers":[{"title":"Default Title","offer_id":63057589928307,"sku":"GOODMAN-0130F00010S","price":26.95,"currency_code":"USD","in_stock":true}],"url":"https:\/\/nationalhvacparts.com\/products\/oem-goodman-flame-sensor-for-ameh961005dxaa-furnace-0130f00010s","provider":"National HVAC Parts","version":"1.0","type":"link"}