{"product_id":"oem-goodman-flame-sensor-for-amec960303anab-0130f00010s","title":"OEM Goodman Flame Sensor for AMEC960303ANAB — 0130F00010S","description":"\u003cp\u003eThe Goodman \u003cstrong\u003e0130F00010S Flame Sensor\u003c\/strong\u003e is a genuine OEM flame-rectification rod built for the \u003cstrong\u003eAMEC960303ANAB\u003c\/strong\u003e gas furnace and compatible Goodman\/Amana models. It confirms the burner flame is present during ignition; if the control board doesn't receive a micro-amp flame-rectification signal within the trial period, it shuts off gas to prevent unburned fuel from accumulating.\u003c\/p\u003e\u003cp\u003eA weak or contaminated flame sensor is the number-one cause of furnace short-cycling — the burner lights, runs for a few seconds, then shuts off and repeats, often ending in ignition lockout. Carbon and oxide buildup on the rod reduces the signal over time. Replacing with the exact OEM sensor restores a clean, reliable flame signal.\u003c\/p\u003e\u003ch3\u003eSpecifications\u003c\/h3\u003e\u003cul\u003e\n\u003cli\u003eOEM Part Number: 0130F00010S\u003c\/li\u003e\n\u003cli\u003eType: Single-rod flame sensor (flame rectification)\u003c\/li\u003e\n\u003cli\u003eSignal: Micro-amp DC flame current\u003c\/li\u003e\n\u003cli\u003eFits: AMEC960303ANAB and compatible Goodman\/Amana furnaces\u003c\/li\u003e\n\u003cli\u003eFunction: Burner flame proving \/ safety shutoff\u003c\/li\u003e\n\u003c\/ul\u003e\u003ch3\u003eOEM vs. Generic\u003c\/h3\u003e\u003cp\u003eThe genuine \u003cstrong\u003eOEM 0130F00010S\u003c\/strong\u003e matches the exact rod length, bend geometry, and mounting bracket your furnace requires for correct flame immersion and signal strength. Generic sensors may fit the terminal but sit at the wrong depth in the flame, producing a low or erratic signal that mimics the very failure you're trying to fix. OEM ensures dependable, code-correct operation.\u003c\/p\u003e\u003ch3\u003eInstallation Difficulty\u003c\/h3\u003e\u003cp\u003e\u003cstrong\u003eEasy (1\/5).\u003c\/strong\u003e Cut furnace power, remove the single mounting screw, disconnect the sensor wire, and install the replacement. Takes about 10 minutes. Avoid touching the rod with bare fingers. If a new sensor doesn't cure short-cycling, inspect the ground and burner alignment.\u003c\/p\u003e\u003cp\u003e100% genuine Goodman\/Amana OEM. Fit questions? Email info@nationalhvacparts.com.\u003c\/p\u003e","brand":"Goodman","offers":[{"title":"Default Title","offer_id":63057555620211,"sku":"GOODMAN-4061","price":26.95,"currency_code":"USD","in_stock":true}],"url":"https:\/\/nationalhvacparts.com\/products\/oem-goodman-flame-sensor-for-amec960303anab-0130f00010s","provider":"National HVAC Parts","version":"1.0","type":"link"}